A common problem with easy fix, over time your down may drop at one corner a little, it then can hit on the lock plate underneath unit, stopping door closing. The doors have a top and bottom hinge, both are adjustable, so you can play with the door to get it to allign again, or simply force (bend) the door locking plate a 'little' downwards to allow door to close.

This is gas running through piping and is normal operation, gas turns from water to gas during the refrigeration process.

The inner Led should be on if switched on (switch is at rear near thermostat dial), if this isn't coming on you need new Led. This is a perishable part not covered under warranty.

Part
LED, part number EC98-Inner-LED, price $29.00, please fill out below to start process.

The inner Led should be on if switched on (switch is at rear near thermostat dial), if this isn't coming on you need new Led. This is a perishable part not covered under warranty.

Part
LED, part number EC98-Inner-LED, price $29.00, please fill out below to start process.

This can happen if;
1. High humidity in the air can cause excess ice on rear cold plate inside fridge, and this also means more water in the self evaporating drip tray under unit to dispurse. So at times you may have water form under unit where tray has over flowed.
2. Unit could have small gas leak, this may show a lot of ice at one corner of the 'cold plate' on inner rear wall of fridge
*If continues after defrosting unit then contact us below.
3. Unit door is not sealing properly, check no big gaps are showing (small gaps are fine)

-Check ventilation around the fridge. You need approximately 20mm at sides and top with 100mm at the rear. 

-The unit cannot have another ‘door’ in front of the fridge door, this is incorrect installation and voids warranty

-The unit must be 100% away from sunlight and out of the weather, this is incorrect installation and voids warranty

 -Check compressor definitely comes ON

-Check what temperature the fridge is set on.  5 is the coldest.